Por favor, use este identificador para citar o enlazar este ítem:
http://inaoe.repositorioinstitucional.mx/jspui/handle/1009/2206| Design of a pressure sensor of 0–7 bar in fiber optic using MMI methodology | |
| VICTOR IVAN RUIZ PEREZ José Javier Sánchez Mondragón | |
| Acceso Abierto | |
| Atribución-NoComercial-SinDerivadas | |
| FOPS Diaphragm Multimode interference Bending Alternative | |
| This research shows the possibility of measuring pressure in the range of 0–7 bar and the comparison against 2 commercial sensors. The technique used is based on the multimodal interference in a fiber optic singlemode–multimode–singlemode (SMS) to 1550 nm. The fiber optic is mounted on a plate of stainless steel AISI 316, where the bending of the plate will generate a curvature on the part of the multimodal fiber generating a decoupling of modes and this generates a low intensity to the output of the system. | |
| Optik | |
| 18-04-2013 | |
| Artículo | |
| Inglés | |
| Estudiantes Investigadores Público en general | |
| Mejía-Aranda, A. R., et al., (2013). Design of a pressure sensor of 0–7 bar in fiber optic using MMI methodology, Optik, Vol. 124(23):5927-5929 | |
| ÓPTICA | |
| Versión aceptada | |
| acceptedVersion - Versión aceptada | |
| Aparece en las colecciones: | Artículos de Óptica |
Cargar archivos:
| Fichero | Tamaño | Formato | |
|---|---|---|---|
| 100. Design of a pressure sensor of 0–7bar in fiber optic using MMI Methodology.pdf | 926.84 kB | Adobe PDF | Visualizar/Abrir |